Dealing With Plosives

Dealing With Plosives

If you don’t avoid capturing plosives in the recording process, you’ll have to deal with them in post-production.

Here are several ways to remove plosives in post:

  • The De-plosive module in iZotope RX
  • A multiband compressor to specifically crush the plosive frequencies which are usually in the range of around 120 Hz and below. Use a high ratio with very fast attack and release, then adjust threshold so that the compressor is only compressing the plosives.
  • FYI, here’s the worst “solution”: Use a high pass filter to roll off the frequencies below ~120 Hz. The problem with this “solution” is that it will not only reduce the plosives but it will remove a significant amount of fullness and body from the sound, which can make the person’s voice sound a bit thin, weak or wimpy.

Also note that De-noise processors will NOT remove plosives.

Is there another method you use to remove plosives? Comment below!

Want to receive the Daily Goody in your email, daily or weekly? Subscribe free here.

And please keep in mind, the Daily Goody is only a tiny little tip, fact or lesson everyday. Please don’t expect any of these posts to be long, earth-shattering masterpieces that instantly answer every single question you can think of and completely transform you into a world class podcast engineer. “Little by little, a little becomes a lot.”

DID YOU KNOW……..We exist for the purpose of helping you, so please comment below with any questions or remarks. We appreciate you listening.

Want to have a career in podcast production?

Browse our online courses on podcasting and audio production to become a qualified engineer.

2 Responses

  1. A free methode but time consuming I’ve been using that I took on YouTube https://youtu.be/Ab4rQdvoX3Q (Home Brew Audio)

    Basically find the pop wave (looks like heart beat) cut on each side and apply take fx eq to remove the low frequencies.

    You can speed it up by creating a script or custom action.

Leave a Reply

Your email address will not be published. Required fields are marked *

Listen To Our Podcast

Discussing Professional Podcast Production - Recording, Mixing, Editing, Mastering. Hosted by Chris Curran - podcast producer, audio engineer, founder of Podcast Engineering School and Fractal Recording.

Subscribe on

Browse Content

Receive
Daily Goody's

Subscribe to the Daily Goodys

Get your daily or weekly dose of goodys

By continuing to use the site, you agree to the use of cookies. More information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close